☣️ UN 1940 • CLASS 8
Thioglycolic acid
Placard: Corrosive. Training/quick-reference only — use current ERG + SOP/SOG for incident-specific actions.
🚒☣️
⚠️ This page is a quick-reference aid. For real incidents: stage upwind, isolate, deny entry, request Hazmat early, and consult the current ERG + SOP/SOG.
Advertisement
Quick details
UN 1940
Class: 8
Placard type: Corrosive
ERG: Guide 153 (check current ERG)
Isolation: ERG 153: isolate spill 25-50m all directions; for large spills isolate 100m and consider evacuation 300m downwind
Chemical & Response Details
| Also known as | Mercaptoacetic acid2-Mercaptoacetic acidTGAThioglycollic acid2-Sulfanylacetic acid |
| CAS Number | 68-11-1 |
| Appearance | Clear to slightly yellow liquid with a strong, unpleasant sulfur-like or rotten egg odor. Corrosive and toxic organic acid. |
| Flash Point | 129C (264F) |
| Boiling Point | 123C (253F) at 29 mmHg; decomposes at higher temperatures |
| Vapor Density | 3.2 (heavier than air) |
| Water Reactivity | Soluble in water; no violent reaction but solution is corrosive and toxic |
| Extinguishing | Dry chemical, CO2, water spray for cooling; avoid direct water stream on spills |
| PPE | ⚠️ Level B minimum with full face respirator; nitrile or butyl rubber gloves required; SCBA recommended in confined spaces or significant releases |
| Isolation | ERG 153: isolate spill 25-50m all directions; for large spills isolate 100m and consider evacuation 300m downwind |
Chemical details are general reference only. Always verify with current SDS, ERG, and SOP/SOG.
Common hazards (high level)
- TOXIC and/or CORROSIVE; inhalation, ingestion or skin contact with material may cause severe injury
- Methyl bromoacetate (UN2643) is an eye irritant/lachrymator (causes flow of tears).
- Contact with molten substance may cause severe burns to skin and eyes.
- Avoid any skin contact.
- Fire may produce irritating, corrosive and/or toxic gases.
- Runoff from fire control or dilution water may be corrosive and/or toxic and cause environmental
- Combustible material: may burn but does not ignite readily.
- When heated, vapors may form explosive mixtures with air: indoors, outdoors and sewers explosion
First actions (field-minded)
- CALL 911. Then call emergency response telephone number on shipping paper. If shipping paper
- Keep unauthorized personnel away.
- Stay upwind, uphill and/or upstream.
- Ventilate closed spaces before entering, but only if properly trained and equipped.
- Isolate spill or leak area in all directions for at least 50 meters (150 feet) for liquids and at least 25 meters
- For highlighted materials: see Table 1 - Initial Isolation and Protective Action Distances.
- For non-highlighted materials: increase the immediate precautionary measure distance, in the downwind
Advertisement
📋 Copy & Share
UN 1940 — Thioglycolic acid HAZMAT RADIO NOTE — UN 1940
Product: Thioglycolic acid
Class 8 / Corrosive / ERG 153
PPE: Level B minimum with full face respirator; nitrile or butyl rubber gloves required; SCBA recommended in confined spaces or significant releases
ISOLATION: ERG 153: isolate spill 25-50m all directions; for large spills isolate 100m and consider evacuation 300m downwind
ACTION: Stage upwind · Isolate · Deny entry · Request HazmatRADIO
Use for: Quick radio or face-to-face size-up. Short, structured, field-ready.
=== IC HAZMAT BRIEFING ===
UN 1940 — Thioglycolic acid
Class: 8 | Placard: Corrosive | ERG Guide: 153
Appearance: Clear to slightly yellow liquid with a strong, unpleasant sulfur-like or rotten egg odor. Corrosive and toxic organic acid.
Water Reactivity: Soluble in water; no violent reaction but solution is corrosive and toxic
Extinguishing: Dry chemical, CO2, water spray for cooling; avoid direct water stream on spills
PPE: Level B minimum with full face respirator; nitrile or butyl rubber gloves required; SCBA recommended in confined spaces or significant releases
Isolation: ERG 153: isolate spill 25-50m all directions; for large spills isolate 100m and consider evacuation 300m downwind
— Key Hazards —
• TOXIC and/or CORROSIVE; inhalation, ingestion or skin contact with material may cause severe injury
• Methyl bromoacetate (UN2643) is an eye irritant/lachrymator (causes flow of tears).
• Contact with molten substance may cause severe burns to skin and eyes.
— First Actions —
• CALL 911. Then call emergency response telephone number on shipping paper. If shipping paper
• Keep unauthorized personnel away.
• Stay upwind, uphill and/or upstream.
• Ventilate closed spaces before entering, but only if properly trained and equipped.
SOURCE: allfirefighter.com/hazmat/un/1940 | Always use current ERG + SOP/SOGIC BRIEFING
Use for: Incident command briefing, staging area whiteboard, or pre-entry team brief. Full chemical + response details.
UN1940 Thioglycolic acid Cls8 ERG153 | ERG 153: isolate spill 25-50m all directions; for large spills isolate 100m and | allfirefighter.com/hazmat/un/1940SMS / 160 CHAR
Use for: Quick text to command or incoming units. Fits in a single SMS. Includes link to full page.
⚠️ Quick-reference only. Always use current ERG + SOP/SOG for incident-specific actions. Page: https://allfirefighter.com/hazmat/un/1940
Advertisement
FAQ
TOXIC and/or CORROSIVE; inhalation, ingestion or skin contact with material may cause severe injury Methyl bromoacetate (UN2643) is an eye irritant/lachrymator (causes flow of tears). Contact with molten substance may cause severe burns to skin and eyes. Avoid any skin contact. Fire may produce irritating, corrosive and/or toxic gases. Runoff from fire control or dilution water may be corrosive and/or toxic and cause environmental Combustible material: may burn but does not ignite readily. When heated, vapors may form explosive mixtures with air: indoors, outdoors and sewers explosion
CALL 911. Then call emergency response telephone number on shipping paper. If shipping paper Keep unauthorized personnel away. Stay upwind, uphill and/or upstream.
Level B minimum with full face respirator; nitrile or butyl rubber gloves required; SCBA recommended in confined spaces or significant releases
No. This is a training/quick-reference aid only. Always consult the current ERG Guide 153 and your department SOP/SOG for incident-specific protective actions.
Sources (high level): DOT/PHMSA marking & class concepts + ERG usage principles. This page does not reproduce ERG guide text—always consult the current ERG for incident-specific protective actions.